![]() Newmar: why oh why did you put the inverter in this location? I could barely get my hand into this area of the inverter. The only way to get in there is to empty out the contents of the slide out and go in, back down, and attempt to work in a highly constricted area. It is mounted, upside down, between the main support rails of the chassis, in one of our slide out bays. Our Magnum inverter is located in the basement of our coach. Perhaps our AC Overload was one of those certain faults? I decided to perform the inverter reset. “Certain faults”? They might be certain but they are not documented in the manual. The Status LED will go off after the button is released. Once the rapid flashing has begun, release the Power ON/OFF button. To perform an inverter reset (also known as a soft reset), press and hold the Power ON/OFF button (see Figure 4-1) for approximately fifteen (15) seconds until the Charging/Inverting Status LED comes on and flashes rapidly. Here is what it said:Ĭertain faults require that the inverter be reset. Although I did not find a specific reference to our situation, a consistent theme around resetting the inverter as a potential solution emerged. There were so many people that had run into issues with their inverter. They were closed and they would not be open for another 4 hours. Nothing to be found there on an AC Overload. And that was the case in dealing with our inverter issue.Īfter the “AC Overload” issue happened, I immediately referenced the manual that came with the Magnum inverter. Documentation is either missing or incomplete. Such is the state of the technology within our coaches. ![]() After spending five hours to resolve a problem that only required the press of a button. Yesterday, all my troubles seemed so far away.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |